Products Information

Model Thomson die-cut unit for top shape and side shape (Side seal)
(Applies to: BH series)
Thomson die-cut unit for top shape and side shape (Side seal)

Outline

Samples

Standard Specifications

Max. film width 580mm
Pouch size Pouch width: 100mm~180mm
(Max. pouch width :218mm, 238mm depending on option ordered)
Pouch length 540mm
*Square pouch making with straight Thomson blade is available using only the Thomson die-cut unit for side shape.
*The pouch size is restricted by the pouch shape and lines.
Standard Die cut size(*1)

[ Thomson die-cut unit for top shape ]
540 mm (Film Width) x 180 mm (Feed Length)
*Max. feed length :218mm, 238mm depending on option ordered
*When all length of Thomson blade is over 1500 mm, it will cause a failure of cutting.
*Some films will cause a failure of cutting not more than 1500 mm.

[ Thomson die-cut unit for side shape ]
600 mm (Film Width) x 75 mm (Feed Length)
*When all length of Thomson blade is over 900 mm, it will cause a failure of cutting.
*Some films will cause a failure of cutting not more than 900 mm.
Non-stop conveyor Pouch feed size: Min.100 mm ~ Max.250 mm
*If pouch feed is over 250 mm,Non-stop conveyor is available to use as a indexing conveyor.
Max. Machine Cycles 120 CPM
*This Max. Machine Cycles is theoretical value.
*Pouch making capacity depends on film material and thickness.
Remark
  1. As the thomson die-cut unit for top shape requires 500 mm space on the film flow, the extension of the machine's main body may be necessary (optional).
  2. Simultaneous use with the optional skipping device is not available.
  3. The life of Thomson blade depends on the film material.

*1) This section shows the basic specifications on each unit. The spacifications may be restricted in case of using two units or more.
* Due to equipment improvement, the above-mentioned figures and appearance may be changed without notice.

Page Top